Instructions for use:
1, After unpacking, check the accessories are complete. (Included accessories list)
2, The pump will configure access nitrate remover corresponding interface, attention must be placed gasket interface area;
3Open the top of the nitrate remover cap, filled with bio-cylinder water, cover and make sure the cap seals intact;
4. Nitrate remover ideal placement for the low light environment, confirm that all piping is properly installed securely, and connect the internal circulation pump power.
5. Rotary inlet valve, adjusting to the off state, without adding the external water, from the beginning to the3Week, and only within the circulating pump, the role is to develop a micro-oxygen areas, allowing growth of anaerobic bacteria.
6. To put this culture anaerobic cycles, it can start adding liquid anaerobic species or anaerobes, this cycle can be shortened to1Weeks.
7. From4Week, the inlet pressure into the water, turn the water regulating valve, observe the meter drop device, adjusted to one drop per second, and then the nitrate remover drops out of the water withNO3Test preparation TestNO3Whether0Eco-cylinder or lessNO3Content doubled (if you smell a slight odor, then it is normal), this time starts nitrate removal has proven to work. This time the nitrate remover drops out of the water should be used to pick up an external container, preventing severe lack of oxygen (hydrogen sulfide) cylinder causing droplets of biological organisms suited.
8. If the first7Items can be passed, every1Days later, the nitrate remover drops out of the water can drip onto the bottom of biological filter inside the cylinder. Partition2Days, from counting the drops is observed at, the water is regulated to second2Drops, separated2Days, withNO3Test agent to test nitrate removal from water drip outNO3Whether0Eco-cylinder or lessNO3Content doubled, and so on, the nitrate remover drops out of the water is adjusted to a reasonable number of drops per second, when the number of drops per second is not reached0Or not less than eco-cylinderNO3Content doubled when should slow the number of drops per second. (Different types of nitrate removal is not the same number of drops, the larger the second treatment water drops more).
9. If the first7Did not pass, then repeat5 -Section7Items.
The nitrate removal can be internal or external, anaerobes food balls1And a half years or melt away leftover1/2Must be added or replaced. Because nitrate removal within the biofilm produced by anaerobic bacteria caused the water is not smooth, the user3-5Day must check the water is normal, if the amount of water slows down, then please immediately adjusted. If prolonged lack the necessary checks can cause clogged inlet or outlet, will lead nitrate removal produce large amounts of hydrogen sulfide inside, this time from the nitrate remover drops out of the water dripping prohibited biological cylinder, have the opportunity to influence biological growth.